How to do when you lift pin 55 on Carprog

Now I have succeeded in one Carprog unit(CARPROG FULL V9.31), with help of a sewing needle. It will go wrong because I get up two pin, and then I can not solder back the faulty pin.

Now I have managed to get another one ready for easy flash with J-Link adapter.
But I will make another one to experiment with, and rebuild to full function or better.


Below is some useful tips from forum bros. Wish this helps


*** autocargo says:

… find scrap electronics board and practice on that. I use thin syringe needle and magnifying glass.. No point practicing on your working CarProgs….

Use thin solder tip or hot air off course…forgot to say… but I don’t think you would be doing it without applying heat…


*** demelec says:

needle under leg needed lifting and heat with hot air, then very carefully lift only a little just so it separates from pcb solder


Soldering iron you have to use very thin tip and just touch very end of leg to remove ( solder at very end so not actually touching leg) then you can lift with needle
And always use solder flux
Flux is the main key to easy working

About the Author

Related Post

Submit a Review

Display Name